Audio-Technica AT-LP2X Bedienungsanleitung Seite 15

Specifications
Turntable specifications
Type
Motor
Drive method
Speeds
Turntable platter
Wow and flutter
Signal-to-noise ratio
Outputs levels
"PHONO"
"LINE"
Phono pre-amp gain
Tonearm specifications
Type
Effective length
Overhang
Maximum tracking error angle
Stylus pressure adjustment range
Applicable cartridge weight range
(including headshell)
Cartridge and headshell specifications
Cartridge Model
Cartridge Type
Recommended load impedance
Output voltage
Stylus
Cantilever
Tracking force range
Cartridge weight
Headshell model
Headshell weight
Headshell overhang adjustment
2-Speed, fully automatic operation
DC motor
Belt drive
33-1/3 RPM, 45 RPM
Die-cast aluminum
< 0.2 % WRMS (33 RPM) at 3 kHz
> 60 dB
3.5 mV nominal at 1 kHz, 5 cm/sec
220 mV nominal at 1 kHz, 5 cm/sec
36 dB nominal, RIAA equalized
Static balanced straight shaped w/soft
damping control
221.5 mm
19 mm
Less than 3°
1 to 4 g
14.5 to 20 g
AT91R
VM Dual Moving Magnet
47,000 ohms
3.5 mV (mV at 1 kHz, 5 cm/sec)
0.6 mil bonded conical
Aluminum pipe
1.5 to 2.5 g (standard 2.0 g)
5.0 g
AT-HS3 BK
11.1 g
8 mm
General specifications
Power supply requirements
Power consumption
Dimensions
Weight
Accessories included
Replacement stylus (sold
separately)
Replacement headshell (sold
separately)
Replacement belt (sold separately) AT-LP2X exclusive belt
Specifications are subject to change without notice due to improvements.
220 to 240 V AC / 50/60 Hz
2 W
435 mm (17.13")×353 mm (13.90")×
128 mm (5.04")
(W×D×H)
5.2 kg (11.46 lbs)
Felt mat, Dust cover, Platter (with
drive belt), Counterweight, Headshell
(AT-HS3) with VM stereo cartridge
(AT91R), 45 RPM adapter, Power cable
ATN91R
AT-HS3 BK
E
N
14