Test Mode - Fronius Acctiva Easy 1202 Bedienungsanleitung

Test mode

General Do not connect the charger to the grid during testing. In all tests, the charger draws its sup-
ply from the battery being tested.
Danger due to exposed, rotating vehicle parts.
This can result in serious injury and damage to property.
► When working in the vehicle's engine compartment, take care that hands, hair, items
Once the charger has been connected to the battery, the following test phases run auto-
matically in sequence:
-
-
-
Please note:
All battery and alternator test results are for information only and may differ from the actual
values.
The charger checks the entire system. The results are therefore to be taken as recommen-
dations only.
Testing the bat- The charger measures the open circuit voltage of the battery. If the battery was not used
tery open circuit for at least two hours, then this is referred to as open circuit voltage.
voltage
1
2
3
4
5
30
WARNING!
of clothing and charging leads do not come into contact with moving parts, e.g. fan belt,
fan, etc.
Testing the battery open circuit voltage
Battery starting capability test (only on chargers for motor vehicle applications)
Generator test (only on chargers for motor vehicle applications)
Switch off engine and ignition, shed all loads
Establish connection to battery
All display elements on the display are activated. Depending on the type of charger,
the respective voltage(s) and/or symbol for the type of battery are displayed.
Charger measures battery open circuit voltage
Charger displays battery open circuit voltage for 15 seconds
100%
Battery ready for use
80% 50% 20%
Charge battery
0%