8
ADJUSTMENTS
8.4
MOW SPEED _____________________________________________________________
Cutting quality is better at speeds well below the
transport speed of the mower. An initial mow speed of
seven to eight mph is set at the factory and should be
satisfactory for most cutting conditions. Local turf
conditions however may respond better to a different
speed.
To set mow speed, loosen jam nut (R), and adjust stop
screw up to reduce speed, down to increase speed.
Tighten nut to hold adjustment in place.
8.5
REVERSE SENSING SWITCH________________________________________________
1. Loosen switch hardware (R).
2. Adjust switch (S) so switch contacts are open with
switch roller contacting the adjustment block (T) and
the traction pedal in Neutral and close when pedal
is moved in the forward direction.
3. Secure switch adjustment and test operation.
4. If adjustment cannot be made, contact your
authorized Jacobsen Dealer.
en-48
H
S
T
Figure 8C
R
Figure 8D