LELY SPLENDIMO L Serie Betriebsanleitung Seite 42

42
- Remove the end plate (9) as well as the swathboard.
- Slide the mower elements and intermediate spacers from
the connecting rod (3).
Assembly of the cutter bar takes place in the reversed order.
Mind the directions listed hereafter.
- Clean the centring rings (10) and the contact areas of the
mower elements and intermediate spacers.
- Make sure that there is no contamination between those
elements and spacers which were not dismounted.
- Fit the elements in the standard configuration of directions
of rotation (fig. A-2).
- A RH rotation disc mower SPLENDIMO L element can
be identified as follows.
When the hub is turned to the right (R - fig. A-3) the
drive gear on the RH side will turn anti-clockwise
(viewed from the rear).
- A LH rotation element can be identified as follows.
When the hub is turned to the left (L - fig. A-3), the drive
gear on the RH side will also turn anti-clockwise.
The disc mowers SPLENDIMO 205L and 280L are fitted with
one extended intermediate spacer (
Make sure that this component is mounted in the correct
position.
Make sure that the mower discs are turned 90° in respect
!
of one another. If a unit can not be slid onto the drive shaft
in one go, its disc needs to be turned a semi-turn one or
several times until the unit can be placed.
- After disassembly of a dis (11) on the hub.
Check the presence of the O-ring in the pressure piece
- Tighten the castellated nut (12) with a torque of 150-250
Nm (15-25 kgm) and secure it with a split pin. Make sure
that the split pin does not protrude above the pressure
piece.
- The securing disc (13) and supporting ring have to be fitted
in the outer mowing element. If this element is replaced,
these parts need to be moved over to the new unit.
Supplement A
, fig. A-2).
SPLENDIMO 165 LN
SPLENDIMO 205 LN
SPLENDIMO 240 LN
SPLENDIMO 280 LN
SPLENDIMO 320 LN
A-2