Connection Cable; Adjusting The Maximum Power-On Volume (Onvol) - Bosch CAD 12 Bedienungs- Und Einbauanleitung

44 | en

Connection cable

A microphone cable (part no. 8 675 501 012)
is available for connecting the microphone to
the device.
Switching the confirmation beep
(BEEP) on/off
For certain actions, e.g. long press of a button,
a confirmation beep sounds. You can switch off
the confirmation beep:
f Press the MENU G button to open the
menu.
f Press the MENU G button repeatedly
until "BEEP" appears on the display, along
with the current setting "ON" or "OFF".
f Turn the volume control B to the left or
right in order to switch the confirmation
tone on or off.
In order to leave the menu,
f press the MENU G button, repeatedly if
necessary.
Adjusting the maximum power-on
volume (ONVOL)
When you switch on the device, it plays at the
previously selected volume. However, if you
adjusted the volume before switch-off to be
higher than the maximum power-on volume,
the volume is automatically limited to the
adjusted power-on volume when you switch it
on again.
Note:
To protect your hearing, the maxi-
mum power-on volume is limited to
25.
7 620 210 015/020-022 | 06.2015
f Press the MENU G button to open the
menu.
f Press the MENU G button repeatedly
until "ONVOL" appears on the display
along with the current setting.
f Turn the volume control B to the left or
right in order to set the switch-on volume
to between 5 and 25.
In order to leave the menu,
f press the MENU G button, repeatedly if
necessary.
Robert Bosch Car Multimedia GmbH
Adjusting the volume