Rimage Everest III Bedienungsanleitung Seite 28

Rimage Everest III printer
4. Install the new print ribbon.
a. Remove the new print
ribbon from the packaging.
b. Install the supply roll end
of the print ribbon on the
top of the carrier.
c. Insert the large shaft in the
large opening and press the
small shaft into place.
Note: The ribbon must
come over the tacky
roller.
d. Wrap the ribbon around the
guide rollers.
e. Install the take up roll.
f. Rotate the take up roll so
the ribbon is aligned and
lies flat.
Tip: You may need to
lift the ribbon up from
the tacky roller to
straighten it.
Note: If you installed a
monocolor ribbon,
advance the ribbon so
the ink portion of the
ribbon is advanced to
the take up roll.
5. Reassemble the printer.
a. Slide the carrier into the printer.
b. Close latch 1.
c. Close the side cover.
6. Power on the printer. The printer is ready.
22
Large
opening
Supply roll
Pull handle
Supply roll
Small
Tacky roller
shaft
Guide rollers
Take up roll
110875_A