Setup 5: Bundle The Cords And Cables; Setup 6: Turn On The Monitor And Computer - Sony SDM-P234 Handbuch

Setup 5: Bundle the cords and
cables
1 Slide up the back cover.
2 Remove the stand cover.
3 Secure the video signal cables, audio cords and
speaker cord (or headphone cord) using the cable
holder on the cabinet.
4 Secure the power cord, connecting cables and
cords using the cable holder.
5 Replace the stand cover and then slide down the
back cover.
Please be sure that cords come out through the opening at the
bottom of the stand cover, for proper placement of the stand
cover.
2 5
stand cover
1 5
back cover
3 4
cable holder
Setup 6: Turn on the monitor and
computer
1 Press the MAIN POWER switch located on the upper
side of the monitor, if 1 (power) is not lit. Make sure
1 (power) is lit in red.
MAIN POWER
2 Touch and hold 1 (power) on the front right of the
monitor for a few seconds.
1 (power) lights up in green.
3 Turn on the computer.
4 Touch INPUT to select the desired input signal.
The selected input's picture appears on the screen.
For more information, see "Selecting the input signal
(INPUT)" on page 11.
INPUT
The installation of your monitor is complete. If necessary, use the
monitor's controls to adjust the picture (page 12).
lights in red
GB
lights in green
9