Samsung HW-N450 Handbuch Seite 28

Sound Control
WOOFER
VOL



• Volume restriction function
Because it may damage hearing when the power is turned on at high volumes, it
adjusts the volume to 20 when the set volume is higher than 20.
– The default value for Volume restriction is off. The set volume is maintained even
when the power is turned off.
– To change the setting, press and hold the Down button on the remote control for
5 seconds. With the volume restriction off, "V FREE" appears on the front display
and with the function on, "V LOCK" appears.
You can select from TREBLE, BASS, or AUDIO SYNC.
• To control the volume of the treble or bass sound, select TREBLE or BASS in Sound
Settings, and then adjust the volume between -6~+6 by using the Up/Down buttons.
• Press and hold the
for each frequency band. 150Hz, 300Hz, 600Hz, 1.2KHz, 2.5KHz, 5KHz, and 10KHz are
selectable using the Left/Right buttons and each can be adjusted to a setting between
-6 to +6 using the Up/Down buttons.
• If the video on the TV and audio from the Soundbar are not synchronised, select AUDIO
SYNC in Sound Settings, and then set the audio delay between 0~300 milliseconds by
using the Up/Down buttons. (Not available in "USB" mode.)
• AUDIO SYNC is only supported for some functions.
Push the button up or down to adjust the volume of the subwoofer to -12 or between -6 to
+6. To set the subwoofer volume level to 0, press the button.
Push the button up or down to adjust the volume.
• Mute
Press the VOL button to mute the sound. Press it again to unmute the sound.
ENG - 24
(Sound Control) button for about 5 seconds to adjust the sound