Sharpening And Caring For The Saw Chain - Parkside PKSA 20-Li A1 Originalbetriebsanleitung

♦ The saw chain must lie against the underside
of the blade.
Check whether the saw chain
brake off, pull the front hand guard
can be drawn by hand over the guide rail
♦ Now tighten the fixing screw
NOTE
► A new saw chain
tightened more often.
Sharpening and caring for the saw
chain
RISK OF INJURY!
► Always wear protective gloves when
handling the saw chain
injury from the sharp cutting teeth!
NOTE
► A properly maintained and sharpened saw
chain reduces the amount of bodily effort and
level of wear and produces a better result.
► Clean, maintain and sharpen the saw chain
regularly.
► Check the saw chain regularly for cracks and
damaged rivets.
► A bench grinder can be attached to the
grinder support
grinding.
► Use only special Ø 4.0 mm (5/32") round
files for saw chains for the supplied saw
chain.
► You will find detailed information on
sharpening in a sharpening set, e.g. from
Oregon.
► Alternatively, you can use an electrical saw
chain sharpening device and follow the
manufacturer's instructions.
► If you have any doubts about carrying out
the work, the saw chain should be replaced.
► If necessary, have the sharpening of the saw
chain carried out by a specialist work-
shop.
PKSA 20-Li A1
(with the chain
to the rear)
completely.
stretches and must be
. There is a risk of
for a secure grip during
■ Required parts (not supplied):
–
Ø 4.0 mm (5/32") round file for saw chains
–
Flat file
–
Depth limiter gauge
.
♦ File using forwards movements only to remove
material.
♦
25°
♦ Check the clearance of the depth limiter with a
depth limiter gauge.
0,65 mm
File at an angle of around
10°
25° at an inclination of 10°
to the guide rail
The correct clearance of the
depth limiter should be 0.65
mm (0.025").
GB │ IE │
.
45 ■