Inserting A Micro Sd Card (Not Included) - THOMSON LENS 150 Bedienungsanleitung

1080P IP AUTONOMOUS CAMERA
C - INSTALLATION
After having scanned the QRCode, the app. checks
whether the camera is switched on. If this is not the
case, it prompts you to switch it on.
Click on "Se connecter à un réseau" (Connect to a
network) and enter the key to the network to which
the smartphone is connected to ensure that the
information is sent to the camera.
IMPORTANT:
The camera is not compatible with 5 GHz WiFi
networks. If necessary, please check the Wi-Fi
parameters of your box with your internet service
provider.
The camera start-up process can only be initiated
once the camera has been switched on and it
switches off after a few minutes for safety reasons.
Switch off the power and switch it back on again
if necessary.
8
EN
Next, place your smartphone as close to the camera
as possible until it has been completely configured.
The information captured will be sent to the camera
at this stage.
Once the camera has been connected to Internet
and picked up by the smartphone, the configuration
page with the date and time embedded in the
image displays.
Adjust this as required and then click on "Afficher la
caméra" (Display camera).
3 - INSERTING A MICRO SD CARD (NOT
INCLUDED)
Your camera has a micro SD card slot, which gives
it an internal storage memory. The maximum size is
128 GB. The slot is located under the battery latch.