EN 34
5.4.7 U
NBLOCKING THE COLLECTOR CHANNEL
Cutting very tall or wet grass, particularly at too high speed, can cause the col-
lector channel to become blocked. Should this happen, it will be necessary to:
– stop forward movement immediately, disengage the blades and stop the
engine;
– take off the grass-catcher or stone-guard;
– remove the accumulated cuttings, reaching them from the exit of the collector
channel.
WARNING!
!
off.
5.4.8 E
ND OF MOWING
When you have finished mowing, disengage the blades, lower the engine speed
and ride the machine with the cutting deck in the highest position.
5.4.9 E
ND OF WORK
Stop the machine, put the accelerator lever in the
«SLOW» position and turn off the engine by putting
the key into the «OFF» position.
When the engine is stopped, close the fuel stopcock
➤
(1) (
if fitted).
WARNING!
!
accelerator in the «SLOW» position for 20 sec-
onds before stopping the engine.
WARNING!
!
unattended!
IMPORTANT
«ON» position when the engine is not running.
This job must only be performed with the engine turned
To avoid backfire, put the
Always take out the ignition key if leaving the machine
To keep the battery charged, do not leave the key in the
HOW TO USE THE MACHINE
1