Unpacking - Franke VITAL CT2.5L Installations- Und Gebrauchsanweisung

These instructions are intended to
provide information regarding correct
installation and operation.
The presence of such warnings does not
imply that the manufacturer assumes
any liability for any damage to property
or injury to third parties caused by the
use of the device, which has all the
original certifications required in order
to make it suitable for the use for which
it has been designed, as well as safe in
compliance with applicable standards.
The reproduction of the contents of this
manual for distribution to third parties
is strictly forbidden without the express
prior consent of the manufacturer.
To ensure safe and efficient operation of
this electrical device:
Only contact authorised service
Z X
centres.
Do not modify any features of the
Z X
device.
This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning
use of the appliance by a person
responsible for their safety. Children
must be supervised to assure that they
do not play with the machine.
This device is not a toy.
Keep children away from the device
Z X
and the packaging material.
Do not leave children near the device
Z X
unattended.
Do not let children play with the
Z X
device.
Do not allow children to touch the
Z X
device or its controls.
The appliance must not be
installed near water jets.
The appliance needs to be
installed on a flat surface.
The appliance must not be
cleaned with water jets.
The appliance is compliant with
the N climate class and must be
installed in locations with a temperature
between +16°C and +32°C. Take all
necessary precautions and do not install
in locations with temperatures lower
than +3°C because if the water inside
the product freezes, it seriously
damages the water circuit.
This appliance generates a sound
pressure level below 70dB.

Unpacking

Place the appliance in the upright
position which can be easily identified by
reading the direction mark „UP" on the
box. Open the package and check that
there are no dents or obvious damages to
the appliance caused by transportation.
Any defects must be notified within
Z X
24 hours from delivery.
In case of obvious defects or dents,
Z X
do not install the appliance.
The packaging must be disposed of by
the customer in accordance with current
environmental protection regulations.
Positioning
Position the cooler in a clean,
Z X
ventilated place and keep away
from heat sources.
Leave a gap of at least 5 cm on each
Z X
side and 25 cm by the ventilation slots.
If the ventilation slots are covered,
Z X
the cooling system cannot operate
properly and this inevitably leads to
malfunctioning.
Do not place any objects on top of
Z X
the product.
– 5 –
EN