Teach Operation; Set All Parameters To "Default; Code Locking Of The Keypad - Kübler 570 Serie Bedienungsanleitung

2.3. Teach operation

The Time-out function will be switched off during all Teach operations
Key Function
ENTER will conclude or abort any Teach operation in progress
SET function is fully similar to normal set-up operation
Cmd will store the display value to the register and will change over to the
next interpolation point.
For details of the Teach procedure see section 6.2.

2.4. Set all parameters to "Default"

At any time you can return all settings to the factory default values.
The factory default settings are shown in the parameter listings in section 6.
When you decide to set all parameters to „default", please be aware that all
previous settings will be lost and you will need to do the whole set-up
procedure once more
To execute the „Default" setting function:
• Power the unit down.
• Press the ENTER key.
• Power the unit up again while the ENTER key is kept down

2.5. Code Locking of the Keypad

When the code locking of the keypad has been switched on, any key access first results in
display of
To access the menu you must press the key sequence
within 10 seconds, otherwise the unit will automatically return to the normal display mode.
0.570_07a_e.doc / Jun-09 Page 10 / 43