Programming Menu; Default Parameters; Table: Parameter Sets; Setting The Basic Function - Kübler Codix 924-4 Bedienungsanleitung

7.8

Programming Menu

7.8.1 Default parameters

Note: Three default parameter
sets have been permanently
stored; these can be adapted as
required. With each
acknowledgment of the
parameter sets, all parameters
will be reset to the values listed
in the table.
The dEFAuL P.USEr can be
freely programmed.
Menu Parameter Sets
Default setting
Parameter set 1
Default setting
Parameter set 2
Default setting
Parameter set 3
Freely programmable
User settings
Factory settings are highlighted
in grey

7.8.2 Table: Parameter Sets

P.SEt 1
Func Count
InP.PoL PnP
FiLtEr on
Count Cnt.dir
MPi LAtch
Loc.InP ProG
ModE Add
www.kuebler.com
The text SAVE is
displayed for 2 s
P.SEt 2 P.SET 3
Count Count
PnP PnP
oFF oFF
uP.dn Quad
LAtch Set
ProG ProG
Sub AddAr
P.SEt 1
FActor 01.0000
diViSo 01.0000
dP 0
SEtPt 000000
CoLor red.Grn
rESmd Man.EL
Pr.Out 1
t.Out 1
Pr.Out 2
t.Out 2
Pr.Out 3
t.Out 3
Pr.Out 4
t.Out 4

7.8.3 Setting the Basic Function

Basic function menu
Programming menu
Pulse counter (7.8.4)
Programming menu
Timer/Hour meter (7.8.6)
Programming menu
Tacho/Frequency meter (7.8.5)
P.SEt 2 P.SET 3
01.0000 01.0000
01.0000 01.0000
0 0.00
000000 0000.00
red.Grn red.Grn
Man.EL Man.EL
00.10
00.10 00.10
00.10
00.10
Page 7