Assembly - Husqvarna S 138i Bedienungsanweisung

Introduction
WARNING: Before you assemble the
product, read the safety chapter.
WARNING: For model S 138i: To prevent
accidental start during assembly, turn the
safety key to 0, remove the battery and wait
at minimum 5 seconds.
For model S 138C: To prevent accidental
start during assembly, disconnect the power
cord.
To assemble the handle
1. Loosen the lower knobs.
2. Move the knobs to the lower end of the grooves on
the left and the right side of the product.
3. Set the handle height in one of the 2 available
positions.
4. Move the knobs up in the direction of the handle until
they stop and you hear a click.
5. Tighten the knobs fully.
14

Assembly

To assemble the grass catcher
1. Attach the grass catcher frame to the grass bag with
the rigid part of the bag on the bottom. Keep the
handle of the frame on top of the grass bag.
2. Attach the bottom section of the grass catcher frame
in the groove on the bottom of the grass catcher.
3. Attach the grass bag to the grass catcher frame with
the clips.
4. Lift the rear cover.
5. Move the grass catcher into the correct position.
937 - 006 -