LAVAZZA firmo INOVY & MILK Bedienungsanleitung Seite 75

N° Problem encountered
Water leaks at the front side of
5
the coffee machine.
Water leaks at the rear side of
6
the coffee machine.
The loading lever does not
reach the supply position or
7
requires an excessive closing
effort.
The display shows the message
8
"SYSTEM TOO HOT".
The display shows the message
9 "ERROR, CONTACT THE
SERVICE CENTRE".
TROUBLESHOOTING
Possible causes
1 - Spent capsule drawer not
inserted correctly.
2 - Spent capsule drawer
filled.
3 - Capsule stuck.
4 - Capsule not compatible.
1 - Tank not inserted correctly. Insert the tank correctly.
2 - Tank damaged.
1 - Spent capsule drawer
filled.
2 - Capsule fitted incorrectly.
1 - Machine overheated
(internally).
1 - Machine damaged, NTC
error.
2 - Machine damaged,
Thermoblock error.
3 - Machine damaged,
internal error.
Solution
Insert the spent capsule drawer
correctly.
Empty the spent capsule drawer
and the drip tray.
Lift and lower the capsule
loading lever. If this is not
enough, disconnect the machine
from power mains and operate
manually to remove the capsule
from the duct.
Use Lavazza capsules or
compatibles.
Check for leaks in the tank
keeping it separate from the
machine.
Empty the spent capsule drawer.
Repeat the sequence, lever in
the off position, lever in the
brewing position; if this is not
enough, operate manually
to remove the capsule from
the duct with the machine
disconnected from power mains.
Wait about 15 minutes, when
the machine is cool press the
MULTIFUNCTION button.
Power cycle the machine.
EN
Result
Ok: call solved.
Non-ok: go to step 2
Ok: call solved.
Non-ok: go to step 3
Ok: call solved.
Non-ok: go to step 4
Ok: call solved.
Non-ok: machine being serviced.
Ok: call solved.
Non-ok: go to step 2
Ok: call solved.
Non-ok: machine being serviced.
Ok: call solved.
Non-ok: go to step 2
Ok: call solved.
Non-ok: machine being serviced.
Ok: call solved.
Non-ok: machine being serviced.
Ok: call solved.
Non-ok: machine being serviced.
75