Abicor Binzel ABIROB A Betriebsanleitung Seite 23

®
ABIROB A
1 Identification
The ABIROB
welding using inert (MIG) or active (MAG) gases. This version is air cooled and can be used
in all welding positions. These operating instructions only describe the ABIROB
torch system. The welding torch system may only be operated with original ABICOR BINZEL
spare parts.
1.1 Marking
This product fulfills the requirements that apply to the market to which it has been introduced. A
corresponding marking has been affixed to the product, if required.
2 Safety
The enclosed safety instructions must be observed.
2.1 Designated use
• The device described in these instructions may be used only for the purpose and in the
manner described in these instructions. In doing so, observe the operating, maintenance
and servicing conditions.
• Any other use is considered improper.
• Unauthorized modifications or changes to enhance the performance are not permitted.
2.2 Obligations of the operator
• Only the following personnel may work on the device:
• those who are familiar with the basic regulations on occupational safety and accident
prevention;
• those who have been instructed on how to handle the device;
• those who have read and understood these operating instructions;
• those who have read and understood the chapter entitled "Safety Instructions";
• those who have been trained accordingly;
• those who are able to recognize possible risks because of their special training,
knowledge, and experience.
• Keep other people out of the work area.
• Observe the occupational health and safety regulations of the relevant country.
• Observe the regulations on occupational safety and accident prevention.
BAL.0125 • 2019-04-15
®
A welding torch system is used in industry and in the trade for shielding gas
1 Identification
®
A welding
EN - 3