Risk Of Injury; Operation; Switching On And Off; Sharpening Drills - Parkside PSS 65 B1 Originalbetriebsanleitung

GB MT
The sharpeners also present a
safety device. Never use this
device without a sharpener.

Risk of injury!

Operation

Caution! Risk of injury!
- Always disconnect the plug from
the mains socket before working.
- Use only grinding disks and acces-
sories recommended by the manu-
facturer. The use of other insertion
tools and other accessories may
cause risk of injury.
- Never operate the device without
the visual protection disk.
- Switch on the equipment only
when it is safely installed on the
work surface.
Despite spark protection, al-
ways wear safety goggles
while working in order to
avoid eye injuries.
Keep your hands away from
the grinding wheel and grind-
ing belt when the device is in
operation. Injury hazard.

Switching on and off

Ensure that the mains voltage match-
es the specifi cations on the rating
plate.
Connect the equipment to the mains.
1. To switch on, press the "I" On switch
and the device starts up (see
2. To switch off, press the "0" off switch
and the device switches off (see
56
After switching on the device, wait until the
device has reached its max. speed. Only
then must you start with the grinding.
The disk will continue to
run after the equipment is
switched off. There is a risk
of injury.
Test run:
Before starting work and after each
change of grinding disk, carry out a test
run of at least 60 seconds with no load.
Switch off the equipment immediately if the
disk runs lumpy, substantial vibrations oc-
cur, or abnormal noises are generated.

Sharpening drills

Drills with a diameter of 3-10 mm can be
sharpened.
1. Mount the selected sharpener (see
Mounting sharpener).
2. Remove the drill holder (14) from the
sharpener.
3. Insert the drill into the drill holder (14).
Do not attach the drill.
4. Insert the drill holder (14) upwards
into the adjusting device (15) using the
knurled nut for drill-fastening (12).
5. Push the drill to the front into the V-nut
up to the metal stop. The cutting edges
of the drill must fi t closely to the metal
surfaces.
6. Using the knurled nut fasten the drill for
drill-fastening (12).
7. Remove the drill holder (14) and insert
3).
this into the rotatable drill mount (11)
3). from below using the knurled nut for
drill-fastening (12).