GB
Mowing with side discharge unit (option)
Important – Danger of injury!
Attach or remove the side discharge unit only
when the motor has been switched off and the
cutting blade is at a standstill.
Fitting the side discharge unit
1. Remove the grass collector and fit the mulching kit.
2. Press the release lever on the cover of the side
11/1).
discharge unit (
3. Open and hold the cover of the side discharge unit
11/2).
(
4. Fit the side discharge tunnel (
5. Slowly close the cover.
The cover secures the side discharge tunnel to
prevent it from falling out.
Removing the side discharge unit
1. Open and hold the cover of the side discharge unit
(
11/2).
2. Remove the side discharge unit and close the cover
11/3).
(
Setting the handle height (optional)
Knob adjustment
1. Press and hold both knobs on the handlebar and
select the desired position (
2. Release the knobs to lock the handlebar in position.
Clamp adjustment
1. Hold the bar and loosen both clamps (
2. Move the bar to the desired position
3. Lock the clamps.
28
11/3).
12/1).
12/2).
Starting the motor
Caution - risk of poisoning!
Never leave a motor running in an enclosed
space.
Caution - Risk of injury!
Do not tilt the lawnmower while starting.
▪ Start the motor only when the blade is mounted
(the blade acts as a flywheel mass)
▪ If starting the motor when hot do NOT use the
choke or primer button
▪ Do not change the motor controller settings
Do not start the equipment if the outlet shaft is not
covered by one of the following parts:
Grass catcher
Deflector plate
Mulch kit
Be particularly careful when operating the starter
switch - follow the manufacturer's instructions
Keep your feet at a safe distance from the cutting
gear
Start the lawnmower where the grass is shorter
Position symbols on the equipment:
Choke*
On
Off
Remote throttle
control*
Start
Stop
Remote throttle
control with
choke*
Vario transmis-
sion*
Fast
Slow
Blade coupling*
On
Off
* depending on version
Translation of original user instructions
Petrol lawnmower