Futurelight DMH-1 Bedienungsanleitung Seite 43

- Status if no DMX-signal
With this function, you can select the status for the case that there is no DMX-signal. You can choose
between „CLOS" for Blackout, „HOLD" for holding the last position, „AUTO" for running the internal
program and „AUDI" for the sound-controlled program-run.
• Select "AUTO" by pressing [UP] or [DN].
• Press [ENTER], the display shows "CLOS".
• Press [UP] or [DN] to select between "CLOS", "HOLD", "AUTO" and "AUDI".
• Press [ENTER] to confirm.
• Press [MODE/ESC] in order to return to the main menu.
- Adjust ventilation fan
With this function, you can adjust the ventilation fan.
• Select "FANS" by pressing [UP] or [DN].
• Press [ENTER] to confirm; the display shows "AUTO".
• Press [UP] to select "HIGH" or "AUTO".
• Press [ENTER] to confirm.
• Press [MODE/ESC] in order to return to the main menu.
Rest
- Reset
With this function you can Reset the device via the Control Board.
• Select "REST" by pressing [UP] or [DN].
• Press [ENTER] to confirm.
• Press [MODE/ESC] in order to return to the main menu.
- Restore factory settings
With this function you can restore the factory settings of the device. All settings will be set back to the
default values (shaded). Any edited scenes will be lost.
• Select "LODA" by pressing [UP] or [DN].
• Press [ENTER], the display shows "ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DN] to select "OFF" if you don't.
• Press [ENTER] to confirm.
• Press [MODE/ESC] in order to return to the main menu.
Ver
- Software version
With this function you can display the software version of the device.
• Select "VER" by pressing [UP] or [DN].
• Press [ENTER], the display shows "V-X.X", "X.X" stands for the version number, e.g. "V-1.0", "V-2.6".
• Press [ENTER] to confirm.
• Press [MODE/ESC] in order to return to the main menu.
- Main menu 2
• Press [ENTER] to enter the main menu (display flashing).
• Press [UP] or [DN] to select "ADJU".
43/48 00051180.DOC, Version 1.0