Herunterladen Inhalt Inhalt Diese Seite drucken

Connection With The Mains; Operation; Stand Alone Operation; Dmx-Controlled Operation - Futurelight DMH-1 Bedienungsanleitung

Led-moving-head
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

With the power switch, you can switch the device on and off.
After you connected the effect to the mains, the DMH-1 starts running. During the reset, the motors are
trimmed and the device is ready for use afterwards.

Stand Alone operation

In the Stand Alone mode, the DMH-1 can be used without controller.
Disconnect the DMH-1 from the controller and call the internal program.
1. Press [MODE/ESC] button to enter the main menu "MODE" (display flashing)
2. Press [ENTER] and select "RUN" by pressing [UP] button.
3. Press [ENTER] and select "AUTO" by pressing [UP] button.
4. Press [ENTER] and select "ALONE" by pressing [UP] button.
5. Press [ENTER] to confirm, the display shows "AU-A".
Please refer to the instructions under Control Board, Main functions, menus Mode and Edit.

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the DMH-1 will respond to the controller.
If you set, for example, the address to channel 12, the DMH-1 will use the channel 12 to 22 for control.
Please, be sure that you don't have any overlapping channels in order to control each DMH-1 correctly and
independently from any other fixture on the DMX-chain.
If several DMH-1 are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the DMH-1
via your lighting controller.
International
L
N
36/48
00051180.DOC, Version 1.0

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis