ETNA RA345BEI Bedienungsanleitung Seite 54

USE
EN 6
3. Within 5 seconds, touch the lighting key until the lighting is on.
4. Within 5 seconds, touch the extraction on/off key.
▷ Wait at least 10 seconds before you using the cooker hood.
▷ If the remote control is replaced, repeat the steps for linking the
remote control. If present, the cooker hood can be connected
to the power supply with the On/Off switch located at the top of
the cooker hood.
Entering a new code for the cooker hood
When interference prevents the remote control from working properly,
a new code can be entered.
5. Touch the remote control's (-) and (+) keys simultaneously for at
least 10 seconds.
▷ The LED on the remote control lights.
6. Once again, touch the (-) and (+) keys simultaneously within
3 seconds.
▷ The LED on the remote control flashes 3x.
7. Work through the steps for linking the remote control.
Replacing the battery
Remove the remote control's cover and replace the battery with a
battery of the same type and voltage. The battery is chemical waste
and must be disposed of in a responsible manner and in accordance
with government regulations.
+
23A