Videotec Ulisse Compact Delux Bedienungsanleitung Seite 8

CAUTION! The white light LED illuminator
emits high-intensity visible light. In
compliance with standard EN62471/
IEC62471, the photobiological safety
assessment has classified the device in
Risk Group 2, where it exceeds the values
of the Exempt Group. The risk linked
to the observer depends on how the
product has been installed and is used. For
installation, follow the instructions in this
manual. Do not open the illuminator for
whatever reason. Do not look directly at the
illuminator using optical lenses. Exposure
hazard values (EHV): 24.3s. Hazard distance
(HD): 200mm.
Fig. 1 White light illuminator.
CAUTION! Device installation and
maintaining must be performed by
specialist technical staff only.
CAUTION! TNV-1 installation type. The
installation is type TNV-1, do not connect it
to SELV circuits.
CAUTION! For continued protection against
risk of fire, replace only with same type and
rating of fuse. Fuses must be replaced only
by service personnel.
CAUTION! In order to reduce the risk of fire,
only use UL Listed or CSA certified cables
with sections greater than or equal to
0.14mm² (26AWG).
6
• The manufacturer declines all responsibility
for any damage caused by an improper use
of the appliances mentioned in this manual.
Furthermore, the manufacturer reserves the right
to modify its contents without any prior notice.
The documentation contained in this manual has
been collected and verified with great care. The
manufacturer, however, cannot take any liability
for its use. The same thing can be said for any
person or company involved in the creation and
production of this manual.
• Before starting any operation, make sure the
power supply is disconnected.
• Be careful not to use cables that seem worn or old.
• Never, under any circumstances, make any
changes or connections that are not shown in
this handbook. Improper use of the appliance
can cause serious hazards, risking the safety of
personnel and of the installation.
• Use only original spare parts. Non-original spare
parts could cause fire, electrical discharge or other
hazards.
• Before proceeding with installation, check the
supplied material to make sure it corresponds
to the order specification by examining the
identification labels (4.2 Product marking, page 9).
MNVCUCHDB_1905_EN