General Maintenance; Initial Break-In Maintenance - Ingersoll-Rand BXR-100H Betriebs- Und Wartungsanweisungen

GENERAL MAINTENANCE

1. Engine RPM is adjusted to:
-1
3,600 – 3,700 min or rpm (with load).
2. Check Bolts and Nuts for looseness. Tighten it if necessary.
3. Check for fuel and oil leak.
4. Keep the RUBBER BUFFER away from oil and fuel.
5. Check the V-Belt and Timing Belt for wear, damage and
cracks. If necessary, replace the belt with new one.
6. Please refer to "INSTRUCTION FOR USE" for HONDA
engine GX 160 regarding the how-to maintenance for
engine.
Air Cleaner
Keep the Air Cleaner Element clean. Take out the outer
urethane foam and inner element. Wash the element in
kerosene or diesel fuel. Saturate it in a mixture of 3 parts
kerosene or diesel fuel and 1 part engine oil. Shake off
excessive oil and reinstall. Wash the air cleaner case using
kerosene. After cleaning it up, apply the engine oil on the inner
part of the case.
CAUTION
If the air cleaner element is seriously contaminated, the
start-up failure, poor output and malfunctions of the engine
may result.

INITIAL BREAK-IN MAINTENANCE

Any new equipment requires an initial modification of the
maintenance schedule to properly break-in the various
component parts. Perform this one time initial break-in
maintenance after 20 to 300 hours of operation in addition to
the normal maintenance schedule. After this initial phase, the
regular intervals should be followed.
Engine Oil
Drain the engine oil after the first 20 hours of operation. Fill with
the correct amount of the recommended oil. Check the oil level
with the oil filler cap/dip stick. See "100 HOUR OR MONTHLY
MAINTENANCE".
Figure 9
Hot oil and/or components can burn.
Oil must be at normal operating temperature when
draining. Avoid contact with hot oil or components.
12-EN
FILLER CAP/
UPPER LIMIT
LOWER LIMIT
WARNING
BXR-100H Reversible Plate Compactors
Operation & Maintenance Manual
DIP STICK