Connect Z21 ® - Detector X16 To The Control Panel; Connection Via R-Bus; Configuration - roco Z21 Detector X16 Benutzerhandbuch

Connect Z21
You can connect the Z21
ZENTRALEpro.

Connection via R-Bus

Z21
®

Configuration

NOTE: The module address assignment for the occupancy detector must not create "address
gaps", i.e. the individual module addresses must be assigned in consecutive numbering. It should
also be noted that a Z21
ed per 8 occupancy detection inputs. When assigning addresses, only the first of these two mod-
ule addresses should be assigned, the second and immediately following address is determined
independently by the occupancy detector.
NOTE: The module address assignment for the occupancy detector must not create "address
gaps", i.e. the individual module addresses must be assigned in consecutive numbering. It should
also be noted that a Z21 Detector X16 uses two consecutive addresses, as one address is needed
per 8 occupancy detection inputs. When assigning addresses, only the first of these two module
addresses should be assigned, the second and immediately following address is determined inde-
pendently by the occupancy detector.
Example: If no occupancy detector module address has yet been assigned, then the first occupan-
cy detector receives the address "1", which leads to an internal assignment of the two module
addresses "1" and "2". After that, by assigning the address "3" to the next occupancy detector,
the module address pair "3" and "4" can be assigned.
8010819920 .indd 21
- Detector X16 to the control panel
®
- Detector X16 via the R-Bus interface on all Z21
®
10819 10808
- Detector X16 uses two consecutive addresses, as one address is need-
®
control panels and the multi-
®
10819 10787
Z21 Detector X16
®_
usw.
21
07.01.2019 09:38:58