Programming / Software - Simons Voss Technologies 3068 Kurzanleitung

The pin code terminal enables you to operate all SimonsVoss G2 lock devices, such
as Cylinder G2, Smart Relay G2 and activation units using a PIN code. There are up to
500 different PINs available. Users themselves can modify their PIN at any time, depen-
ding on the configured modes. There is no need to include the system administrator to
do so. SimonsVoss G2 locking systems (with an access control function, i.e. access
and time zone control) also allow system operators to authorise a person or a user
group to access a building on a time-limited basis and also log which particular PIN
gains access at a particular time.
3.2

PROGRAMMING / SOFTWARE

The following components and software are required to programme and use the pin
code terminal:
: : LSM 3.1 SP1 or higher
: : SmartCD.G2
: : G2 lock devices
4.0 GENERAL PROGRAMMING
4.1 TRIVIAL PIN
The system does not allow very simple PIN codes to ensure that the pin code terminal
offers a high level of security.
The following trivial PINs are not permitted:
: : PINs with an ascending sequence of numbers
: : PINs with a descending sequence of numbers
: : PINs with the same number repeated more than twice in succession
If a PIN is selected with such a sequence of numbers, the system automatically rejects
the PIN.
20