Trimming/Adjust; Camera Start-Up - ACME FlyCamOne Anleitung

zoopa 300 Movie

Trimming/Adjust

Camera

Camera Start-Up

MIC LED
Modes
The different modes are displayed by the LED – the color shows the action.
Video
Serial Photo
Photo
Camera
Read the recorded data
You have the following possibilities to read videos and photos:
» Connect the cam to the computer by using the USB port (on the right side of the helicopter).
» Insert the micro SD card into a card reader or SD Adaptor.
» You do not need a driver to read data from the camera.
We recommend the free video player "VLC-Player" to watch the videos. Download at videolan.org/vlc
If the helicopter turns around its own shaft after the start, you can adjust it by turning
the trimming wheel on the right top of the controller to stabilize the flight attitude.
Insert a micro SD-Card (up to 8 GB, not included) into the card slot on the right
side of the helicopter with the contacts pointing in the direction of the rotor blades
until it audibly clicks into place. The memory card should at least offer a writing
speed of 4 MB/sec., in order to avoid bad recordings. Adjust the camera head for
optimal recording. Turn on the cam using the switch.
USB
CARD
Stand-By
LED green, permanent light
LED flashes green, flash frequency 1x/sec.
LED flashes green, slow flash frequency
1x/2 sec.
To Start/Stop recording in the chosen mode, quickly switch the left contact switch on and
off. To switch the mode, hold for 3 seconds. You can also change the mode by pressing
the small white button on the camera's circuit board. If you press the contact switch for
10 sekunds the recording is flipped by 180°.
LED red, permanent light
LED flashes red, flash frequency 1x/sec.
LED flashes red once for every shot
14
Recording