Using the parking cooler
Always observe the following:
z If you would like the parking cooler to match the colour of your vehicle,
only paint the upper shell casing of the parking cooler.
Only paint this when it has been removed. Use light colours when
possible.
z Wash your vehicle regularly, as dirty driver's cabs heat up more quickly.
z Make sure that the performance of the parking cooler is not affected by
other sources of heat (e.g. waste heat from cold machines).
7.2
Switching on the parking cooler
A
NOTICE!
Never close all of the air nozzles of the parking cooler simul-
taneously. The system would ice up inside.
I
NOTE
The first time the parking cooler is used, there may be a slight
smell. This odour is caused by a design feature and ends after the
system has been running for a short time.
➤ With the system switched off, press the
✓ The fan starts.
✓ The Power LED (fig. 2 7, page 3) lights up.
✓ The digital display (fig. 2 1, page 3) shows the current status of the
parking cooler (see chapter "Display" on page 12).
I
NOTE
Depending on the system status, the system compressor is
switched on with a delay of up to 180 seconds.
14
CoolAir RTX1000, RTX2000
button.
EN