EUROM Force 1218 Ash Cleaner Metal Bedienungsanleitung Seite 31

 Remove the plug from the socket.
 Roll up the electrical cable.
 Open both clamps (10) and remove the motor cover (3) from the boiler (5).
 Empty the boiler. Remove the dirt from the boiler and clean the boiler. If you need
to use water, dry it thoroughly!
 Clean the filter. Pull the HEPA filter from the motor block (A) and clean it: clean
the outside with a different vacuum cleaner (B) and the inside, if necessary with
a hand sprayer (C). Never clean the outside with water (D), because then the dirt
will be forced in! Do not use any aggressive or abrasive cleaning agents and allow
the HEPA filter to dry thoroughly before replacing it. Finally, slide the HEPA filter
firmly back into place: the white switch on the bottom of the engine must be
pressed by the HEPA filter.
Caution: The device will not work without a properly installed HEPA filter!
 Replace the motor cover (3) on the boiler (5) and close both clamps (10).
Maintenance
 Keep the boiler (exterior), motor cover and accessories clean by cleaning them
with a dry or, if necessary. damp cloth. Do not use aggressive cleaning agents!
 Regularly check that no false air is sucked in anywhere.
 Check the electrical cable and plug for damage regularly. Do not use the device
with a damaged cable and/or plug, but have it replaced by a qualified technician!
 Regularly check that no objects in the nozzle, hose or pipe are obstructing the
suction. Remove them if necessary.
 Use the device carefully and with caution; make sure it does not fall, bump or is
otherwise damaged.
 Store the device in a dry environment.
 Do not allow the device to run for too long, but allow it to cool down regularly.
This extends the service life.
 If the device fails, vibrates, makes a strange noise or emits a burning odour,
immediately stop use and send the device to your supplier or service centre for
inspection/repair.
Security
The device is equipped with an overheating protection. The overheating protection
switches the device off if it becomes too hot inside. When this happens switch off
31