Setting The Clock; Setting Alarm - ECG MS 007 Bedienungsanleitung

Manual signal reception: Simply press and hold
reception. Press and hold
When your weather station receives radio time signal, the display darkens. When the radio time signal is
received, the display returns to the previously set brightness level.
During radio time signal reception, the buttons of the device do not work and no temperature measurements
are carried out. The display shows the original temperature. Current, accurate temperature returns to display
after about 30 minutes.

SETTING THE CLOCK

Hold the SET button for 2 seconds, the numbers on the clock start flashing. Using
1.
2. Press again SET, the minute numbers start flashing. Using
Press SET once again. The display shows flashing :05. Using
3.
5–60 minutes range.
Then press SET once again. The display shows 00. Using
4.
"00" = GMT +1 hour (i.e. Czech Republic)
"01" = GMT +2 hours (i.e. Finland)
"-01" = GMT 00 (i.e. Great Britain)
Press SET to return to regular mode. When you will not press any button within about 10 seconds the
5.
device will return to regular mode automatically.
6. The clock is set in 24 hours format.

SETTING ALARM

(The default alarm clock setting is 6:00)
Press and hold the AL button. The hours and the symbol AL start flashing. Using
1.
wake up time.
2. Press ALagain, the minute numbers start flashing. Using
3. When you press AL again, you will save the alarm setting and return to regular time display. When you
will not press any button within about 10 seconds the device will return to regular mode automatically.
ALARM CLOCK TURN ON AND OFF
You will switch the alarm clock on or off by pressing AL. When the alarm is on, symbol AL appears above the
time display.
SNOOZE
When the set alarm time is reached the alarm clock starts ringing and the AL symbol is flashing.
Press snooze once SNOOZE to switch the alarm off temporarily, symbol AL continues flashing. If you did
1.
not set another snooze time interval, the alarm will ring again 5 minutes later.
2. If you want to switch the alarm clock off, press during ringing any button but snooze.
Alarm duration: 2 minutes
DISPLAY BRIGHTNESS SETUP
Press SNOOZE/DIMMER to set the display brightness high or low.
USING THE WEATHER FORECAST
The weather station uses four weather symbols:
/WAVE to stop DCF reception.
/WAVE. The device beeps briefly and starts manual
/ set minutes.
/ set the snooze interval in the
/ select the time zone.
/ set minutes.
/ set hour.
/ set the desired
EN
45