Prior To Use; Inserting / Changing The Batteries; First Use; Switching On The Bathroom Scales / Measuring Weight - Silvercrest SPWC 180 A1 Bedienungsanleitung Und Sicherheitshinweise

SilverCrest SPWC 180 A1

6. Prior to use

6.1. Inserting / changing the batteries

To insert or change the batteries, remove the cover from the battery compartment (6) on the bottom
of the bathroom scales by pressing the ribbed surface with two fingers and then sliding the cover in
the direction of the arrow.
Now insert the supplied batteries or change the batteries if they are empty. Pay attention to the
polarity (note + and -) when inserting the batteries. The polarity is illustrated on the batteries and in
the battery compartment (6). Then replace the cover on the battery compartment (6) until it snaps
into place.

7. First use

7.1. Switching on the bathroom scales / measuring weight

The bathroom scales must be calibrated before first use or after having been
moved to ensure that they can determine one's weight exactly. To do so, step
briefly on to the tread (2), step off it again and wait until the bathroom scales
switch off automatically. The bathroom scales are now calibrated.
Due to the step on power function, the bathroom scales are switched on automatically when you
step on the tread (2) and they start to measure your weight immediately.
A solid surface is required to measure weight correctly. Thus always place the
bathroom scales on a solid, horizontal floor covering and never on carpet.
This can distort the measurement result.
To obtain comparable measurement results, you should always weigh yourself
if possible at the same time of day (preferably in the morning). Always weigh
yourself if possible under the same conditions: on an empty stomach, after
having gone to the toilet and naked.
20 - English