Switching The Cool Bag On Or Off; Energy Saving Tips; Using Corkscrew/Bottle Opener - Crivit CKT 12 A2 Bedienungsanleitung Und Serviceinformationen

12V Electric Cool Bag Crivit CKT 12 A2
Place the connection cable in the vehicle so that the driver is not impeded as there will be a
danger of accidents otherwise.
Secure the cool bag in the vehicle to prevent uncontrolled movements so that it cannot pose a
risk for the vehicle occupants in the event of an accident or during a hard braking manoeuvre.
Store the cool bag in the boot of the vehicle for safety reasons.

Switching the cool bag on or off

You must make sure that your vehicle has a 12 V car power supply. The cool bag must not be
used with a 24 V car power supply.
Unwind the connection cable completely. Now insert the cigarette lighter plug [5] into a suitable
cigarette lighter socket of your vehicle. The cool bag is now switched on and begins to cool. The
LED on the cigarette lighter plug [5] lights up green in operating mode. To switch off the cool bag,
disconnect the cigarette lighter plug [5] from the cigarette lighter socket of your vehicle.
Since the cigarette lighter socket of some vehicles supplies power even if the ignition is
switched off, you should disconnect the cigarette lighter plug [5] from the cigarette lighter
socket of your vehicle when leaving the vehicle. Otherwise, the battery of your car could run
down to such an extent that you cannot start the car engine.

Energy saving tips

Do not expose the cool bag to direct sunlight.
Only use previously cooled food and drink.
Do not open the cool bag for longer than necessary and close the bag cover completely with
the drawstring [2].
Ensure that air can circulate between the items to be cooled. You can fill the cool bag at most,
for example, with six upright 1L bottles or 18 upright 0.33L beverage cans (67mm in diameter
x 115mm in height).

Using corkscrew/bottle opener

You will find a corkscrew/bottle opener [8] in the pocket with Velcro fastener [9] in the front lined
outer pocket [4]. The corkscrew/bottle opener [8] is attached with a snap hook to a strap so that it
cannot be lost. You can detach the corkscrew/bottle opener [8] from the snap hook in order to use
it. Do not use the corkscrew/bottle opener [8] as a tool. The corkscrew/bottle opener [8] is to be
used solely for opening bottles with corks or crown caps. Any other use is not as intended. When
you open a corked bottle, you can use the knife of the corkscrew/bottle opener [8] to cut a capsule
that may be present and then remove it. To use the knife that is intended solely for this purpose, fold
40 - English