Fellowes Galaxy e Wire Bedienungsanleitung Seite 6

ENGLISH
CORRECTING A BOUND DOCUMENT
Wire binding is a secure binding system. Additional sheets cannot be added unless the document is disassembled and then re-bound.
REMOVAL OF WASTE CLIPPINGS
The waste tray is located under the machine and is accessed from each side. For best results empty the tray regularly.
The tray should be emptied after every 50 operations to ensure no blockages occur.
STORAGE
Lower the lid. The Galaxy wire binder is designed to be stored horizontally on the desk.
TROUBLESHOOTING
Problem
No Green power neon
Red standby neon
Cannot close wire comb tightly enough
Damaged hole edges
Waste tray leaks
Punched holes are not central
Machine will not punch
Punch holes are not parallel to edge
Partial hole edges
Sheets fall out of document
WORLDWIDE WARRANTY
Fellowes warrants all parts of the binder to be free of defects in material and workmanship
for 2 years from the date of purchase by the original consumer. If any part is found to
be defective during warranty period, your sale and exclusive remedy will be repair or
replacement, at Fellowes' option and expense, of the defective part. This warranty does not
apply in cases of abuse, mishandling or unauthorised repair. Any implied warranty, including
that of merchantability or fitness for particular purpose, is hereby limited in duration to the
6
Cause
Machine is not switched on
Machine has overloaded when punching
Closing jaws set at too large a diameter
Possibly overloading the machine
Waste tray is not correctly inserted or 'burst
feature' has activated
Edge guide not set
Blockage
Debris is stuck below dies
Sheets not correctly aligned to punch pattern
Wire comb is not closed enough
Solution
Switch on machine at rear next to plug inlet
Press the punch button. The machine will withdraw the punches
and re-set itself. Continue this process until the punch cycle is
complete
Revise closure lock setting to suit smaller diameter as required
Punch plastic covers with paper sheets. Reduce number of
sheets being punched
Check waste tray is empty and 'burst feature' is closed
Adjust edge guide until hole pattern is correct
Check waste tray is empty. Check for blockage to paper entry
Take stiff cardboard and slide into the paper entry. Move the
cardboard sideways to release any stray clippings into the
waste tray
Adjust edge guide and test punch scrap sheets until correct
Check closure of wire comb. Place into closing mechanism and
improve binding closure. Revise closure lock setting to suit
smaller diameter as required
appropriate warranty period set forth above. In no event shall Fellowes be liable for any
consequential damages attributable to this product. This warranty gives you specific legal
rights. You may have other legal rights that vary from this warranty. The duration, terms
and conditions of this warranty are valid worldwide, except where different limitations,
restrictions or conditions may be required by local law. For more details or to obtain services
under this warranty, please contact Fellowes or your dealer.