Basic Operation; Volume Control; Dab+ Operation - LENCO DAR-045 Benutzerhandbuch

To replace a new battery, please refer to the figure shown below. When inserting a battery, be sure to do so in the proper direction.
Push in according to this direction
●
If the remote control conflicts with other devices, the operation will be affected.
●
Do not simultaneously press buttons on the unit and the remote control.
●
Avoid using two remote controls at the same time as it will cause a malfunction.
●
Use only CR-2025 size batteries.
●
If there is battery leakage, clean the remote control thoroughly before replacing batteries.
●
Do not short two terminals of the batteries. Dispose old batteries in a suitable place.

BASIC OPERATION

Plug the AC/DC power adaptor into a AC mains outlet and the other end of the cable into the DC IN 9V jack at the back of the unit.
The display will show "SCANTIME". The unit is now updating the time from the broadcaster. Wait for a while until it is finished and the
real time will be display.
Press the STANDBY button to turn on the unit. To turn off, press the STANDBY
DAB+/FM/CD/AUX/Bluetooth
Press the SOURCE button to choose the different sources.

Volume Control

Press the VOLUME +/- buttons on the unit or the VOL-/+ buttons on the remote control to change the volume.
Adjusting the Antenna
The antenna wire at the rear panel of the unit should be extended to ensure a good DAB+/FM reception. Alter the antenna position
for the best reception.

DAB+ OPERATION

The first time the DAB+ mode is selected, it will automatically scan for available DAB+ stations. Wait until the scanning has finished.
The display will show the scanning progress. After scanning it will tune to the first station.
Auto Scan
1. Turn on the unit in DAB+ mode.
2. Press the SCAN button to start auto-scanning the available stations.
Battery case
CR2025 battery
8
Pull out the battery case
button again.