Gloria 141 T Spezial Betriebsanleitung Seite 11

Innenseiten.qxd
● Check the functioning of the unit each
time before startup, and make a spe-
cial check of the hose connection and
the screw connectors. Check the ma-
terial for tears, brittleness and corro-
sion.
● Thoroughly clean out the tank im-
mediately after use, and then dry it
well (see Emptying and Servicing).
Do not store spraying agent in the
tank.
● Spraying agents that are environ-
mentally harmful should be use up as
far as possible on the object of the
spraying, any unavoidable residues
should be put in a suitable holding
container and sent for special dis-
posal. Observe the German Water
Protection Law (WHG) for liquids that
are harmful to the groundwater. Ob-
serve the German Ordinance on the
Storage of Liquids that are Harmful to
the Groundwater (VLwF) when stor-
ing liquids; also observe the German
Working Materials Ordinance, Tech-
nical Instruction Air (TA-Luft).
● Do not leave the filled tank in strong
sunshine. Do not exceed operating
temperatures of 50°C.
● Store the unit in a place out of the
reach of children. Do not leave a
ready-filled unit unattended at the
place where it is being used.
04.05.2006 17:01 Uhr
● No persons should be in the area of
● Thoroughly clean out the tank im-
● Caution!
● The safety valve (diagram A)
13
Seite 13
the spray mist during the spraying
operation.
mediately after use, and then dry it
well.
Please note that under product lia-
bility law we are not liable for dam-
age resulting from the use of our
product if such damage was caused
by improper repair or if original GLO-
RIA replacement parts were not
used to replace defective or worn-
out parts and the repair was not car-
ried out by our Customer Service or
by an authorized service technician.
This also applies to accessories.
(under the filter funnel) must be
checked each time before startup!
Insert the pump and screw it up
tight. Operate the pump until the
pressure gauge shows no further in-
crease (the safety valve blows off the
excess pressure). The maximum
pressure shown on the pressure
gauge must never exceed 6.6 bar.
GB