Danger For Children - Silvercrest SHH 1200 A1 Bedienungsanleitung

*%B&3(B+HL]VWUDKOHUIP 6HLWH  0LWWZRFK  -XQL    
~ In order to prevent overheating of the heating device, the heating
device must not be covered.
~ The device must never be set up directly under a wall socket, as
the forming heat may lead to damage to the electric system.
~ Never use the device close to a sink, a bath tub, a shower or a
swimming pool, as water splashes could enter the device.
~ If the power cable of this device should become damaged, it
must be replaced by the manufacturer, the manufacturer's custom-
er service department or a similarly qualified specialist, in order
to avoid any hazards.
~ This heating device must not be used with a mode switch, a time
switch, a separate remote control system or any other system, which
automatically switches on the heating device, because this will lead
to a fire hazard if the device is covered or positioned incorrectly.
~ WARNING! This device is not equipped with a feature for regu-
lating the room temperature. The heating device must not be used
in small rooms, in which people not able to leave a room of their
own accord live, unless permanent monitoring is in place.

DANGER for children

~ Packing materials are not children's
toys. Children should not be allowed to
play with the plastic bags: There is a
risk of suffocation!
~ Keep the device out of the reach of chil-
dren.
DANGER! Risk of electric
shock due to moisture
~ The device, the power cable and the
mains plug must not be immersed in wa-
ter or any other liquids.
~ Protect the device from moisture, water
drops and water splashes.
~ If liquid gets into the device, remove the
mains plug immediately. Have the de-
vice checked before reusing.
~ Never touch the device with wet hands.
~ If the device falls into water, disconnect
the mains plug immediately. Only then
is it safe to retrieve the device.
DANGER! Risk of electric
shock
~ Only connect the mains plug to a proper-
ly installed and easily accessible wall
socket whose voltage corresponds to the
specifications on the rating plate. The
wall socket must continue to be easily ac-
cessible after the device is plugged in.
~ Ensure that the power cable cannot be
damaged by sharp edges or hot points.
~ The device is not fully disconnected from
the power supply, even after it is
switched off. In order to fully disconnect
it, pull out the mains plug.
~ When using the device, ensure that the
power cable cannot be trapped or
crushed.
~ When removing the mains plug from the
wall socket, always pull the plug and
never the cable.
41
GB