Redmond RMC-M13 Bedienungsanleitung Seite 15

Display
A. "Таймер" ("Timer") indicator — is lit when adjusting cooking time/ during
programme operation.
B. "Отсрочка" ("Time Delay") indicator — is lit when adjusting Time Delay /
during appliance operation in Time Delay.
C. Disabled audible signals indicator.
D. Keep Warm indicator.
E. "Разогрев" indicator — is lit during Reheat function operation.
F. Temperature value indicator in "МУЛЬТИПОВАР" programme.
I. PRIOR TO THE FIRST USE
Carefully unpack the device, remove all packaging materials and stickers except
the one with the unit's serial number.
The absence of the serial number will deprive you of your warranty benefits.
After transportation or storage at low temperature allow the appliance to stay
at room temperature for at least 2 hours before use.
Wipe all interior and exterior surfaces of the unit with a soft, damp cloth. Wash
the bowl in warm soapy water. Rinse and dry thoroughly. Odour on first use of
the appliance is normal. In such case, clean the device .
II. OPERATION
Before use
Place the device on a flat, stable, and hard surface away from wallpaper, deco-
rative coatings, or any other objects or cabinets that could be damaged by steam,
humidity, or high temperatures. Before operating the appliance, ensure that the
outer and inner parts of the pressure multicooker have no dents, cracks or any
other visible damages. There should not be any obstructions between the
heating element and the bowl.
Standby mode
The plugged in appliance has default standby mode setting; current time is
displayed in 24-hour format. If no button was pressed during one minute when
setting selected programme parameters, the appliance will switch to the
standby mode; all the previous settings will be cleared.
To adjust the clock
To adjust the current time:
1. Press and hold "Час/Мин" button for several minutes in standby mode.
indicator will be lit on the display; clock register indicator will be flashing.
2. Select clock value rotating adjustment ring this or other way. Repress "Час/
Мин" button to switch the register and turning the adjustment ring adjust
the minute value. After maximum value is reached the adjustment starts
from beginning of the adjustment range.
3. When time adjusting is complete do not press any buttons. The adjusted
time value will be saved in a few seconds.
Enable/disable audible signals
The REDMOND RMC-M13, RMC-M23, RMC-M33 multicookers allow to enable/
disable audible signals, that accompany pressing the buttons and the end of
cooking process. To disable/enable audible signals press and hold "Отмена"
button in standby mode.
Non-volatile memory
The REDMOND RMC-M13, RMC-M23, RMC-M33 multicookers have non-volatile
memory. If power failure occurs during programme operation (up to 15 minutes
in cooking mode) the appliance saves all settings to the memory. The appliance
will start operation on the interrupted stage. Press the "Отмена" button if it is
undesirable to the continue cooking process. The appliance will switch to the
standby mode.
To adjust cooking time
The REDMOND RMC-M13, RMC-M23, RMC-M33 multicookers provide default
cooking time adjusting. Time interval and range depend on selected cooking
programme.
1. Select the programme rotating the adjustment ring this or that way.
The "Таймер" indicator will be lit on the display, default cooking time will
be displayed for every programme.
2. Press the "Настройка" button. The clock register indicator will be flashing.
3. Select the time value rotating adjustment ring this or that way. Repress
the "Час/Мин" button to switch the register and adjust minute value
turning the adjustment ring. After the maximum value is reached in every
register the adjustment starts from beginning of the adjustment range.
Time Delay
The time delay function allows adjusting time by which the dish will be ready.
The maximum time of delay is 24 hours in 15 minutes interval. It should be
taken into account that Time of delay should be more than adjusted cooking
time otherwise the programme will start the operation after pressing the "Старт/
Автоподогрев" button.
1. Select the programme, adjust the cooking time if necessary. Adjust the cook-
ing temperature for the "МУЛЬТИПОВАР" programme.
2. Press the "Настройка" button. The "Отсрочка" and the time value indicators
will be flashing.
3. Adjust the time value rotating the adjustment ring. Repress the "Час/Мин"
button to switch the register and adjust the minute value turning the
adjustment ring. After the maximum value is reached in every register the
adjustment starts from beginning of the adjustment range.
4. Press the "Старт/Автоподогрев" button. The appliance will switch to the
Time Delay mode, the "Отсрочка" and the current time indicators will be
lit. Press the "Час/Мин" button to see the adjusted time by which the food
will be ready.
5. Press the "Отмена" button to clear the current settings. The cooking pro-
gramme should be adjusted all over again.
Avoid using the Time Delay function for perishable products.
The Time Delay function is not applicable for the "ЭКСПРЕСС", "ЖАРКА",
"ПЕЛЬМЕНИ", "МАКАРОНЫ", "МАНТЫ", "ФРИТЮР" programmes.
Keep Warm function
This function automatically activates in the end of cooking cycle and keeps the
food warm at 70-75°С for 12 hours. Direct countdown is lit on the display. To
disable the Keep Warm press and hold the "Старт/Автоподогрев" button
(the Keep Warm indicator will go out).
Though Keep Warm mode is designed for 12 hours, it is not recommended to
leave food heated for a long time, as it may lead to food overdrying and change
in its taste qualities.
The Keep Warm mode is not applicable for the "ЭКСПРЕСС", "ЙОГУРТ",
"ДРОЖЖЕВОЕ ТЕСТО", "ДЕТСКОЕ ПИТАНИЕ", "ПЕЛЬМЕНИ", "МАКАРОНЫ",
"МАНТЫ", "ФРИТЮР" programmes.
In "ХЛЕБ" programme Keep Warm operation is 3 hours, in "ВЫПЕЧКА" and
"ЗАПЕКАНИЕ" programmes — 4 hours.
Keep Warm disabled in advance
The Keep Warm mode may be disabled in advance if necessary. To do so after
the start of cooking programme repress and hold the "Старт/Автоподогрев"
button until the Keep Warm indicator goes out.
In the same manner the Keep Warm function may be activated again (the Keep
Warm indicator will be lit up solid).
When cooking at the temperature below 80°С the Keep Warm function has a
default block setting for your accommodation. It can be manually adjusted by
RMC-M13, RMC-M23, RMC-M33
pressing the "Старт/Автоподогрев" button after the start of cooking pro-
gramme if necessary (the Keep Warm indicator will be lit up solid).
Reheat
Provides reheating cold meals:
1. Fill the bowl with food and position it inside the appliance. Ensure it is
tightly connected to the heating element.
2. Close the lid until it clicks into place. Plug in the appliance.
3. Press the "Разогрев" button. The "Разогрев" indicator will light up solid,
the Reheat function will be activated and direct minute countdown will
start. The meal will be reheated to 70-75°С. The temperature may be
maintained for 12 hours.
4. Press "Отмена" to disable the Reheat.
Though the multicooker can keep food warm up to 12 hours, it is not recom-
mended to leave food reheated for a long time, as it can affect its taste
qualities.
Standard operating procedure for automatic programmes
1. Prepare (measure) the ingredients. Fill the multicooker bowl with ingre-
dients according to the cooking programme and position it inside the
appliance. Ensure that all ingredients are evenly disturbed below the
maximum fill mark on the inside of the bowl.
2. Position the bowl into the housing. Ensure that it makes full contact with
the heating element. Close the main lid until it clicks into place. Plug in
the appliance.
3. Select the cooking programme turning the adjustment ring. The corre-
sponding indicator will be flashing, the "Таймер" and the default cooking
time indicators will be lit.
4. Adjust the cooking time if necessary. You can also adjust the temperature
for the "МУЛЬТИПОВАР" programme.
5. Adjust the Time Delay if necessary.
6. Press the "Старт/Автоподогрев" button to begin the cooking cycle. The
button indicator will be lit, the countdown will be lit on the display.
7. An audible signal will be produced to indicate that cooking cycle is com-
plete, the programme indicator will go out on the display. Depending on
the selected programme or current settings the appliance will either
enter the Keep Warm (the Keep Warm indicator and the direct countdown
of the programme are lit on the display) or Standby mode.
To cancel the programme, to interrupt the cooking cycle or the Keep Warm
mode press the "Отмена" button.
"МУЛЬТИПОВАР" programme
The "МУЛЬТИПОВАР" programmeme is recommended for cooking any dishes
with the cooking temperature and time adjustment. The cooking time can be
manually adjusted between 2 minutes and 12 hours with 1 minute interval.
The temperature can be adjusted between 35 and 170°С with 5°С intervals.
The default cooking time for this programmeme is 100°С.
Press the "Настройка" button to adjust the cooking temperature and switch to
the corresponding mode (repress the button if cooking time was changed, or
press the button twice if the default cooking time is used). The temperature
value indicator will be flashing.
Turning the adjustment ring this or other way, select the desired temperature
value.
After the maximum value is reached the adjustment starts from the beginning
of the adjustment range. Then follow par. 5-7 of the "Standard Operating Pro-
cedure for Automatic Programmes" section.
"ЭКСПРЕСС" programme
The programme is recommended for cooking rice, fluffy porridge, cooking dif-
ferent foods.
GBR
15