Error Messages - Blue Eco 240 Gebrauchsanleitung

Error messages

When there are errors or changes occur the output to the pump will be stopped and the display will give an ALERT message. The 3rd
line in the display will indicate the error code.
Over Voltage The DC voltage is too high.
Low Voltage The voltage in the controller is below 190 V.
The current of pump get too big suddenly,
Over Out Current
and controller stop output to protect the pump.
P 2 P Error There is a short circuit or an open conncetion between the two output phases.
Data Error The data in eeprom get wrong.
All Data Initial All data in eeprom was initialized.
User Data Initial User data in eeprom was initialized.
Key Data Modified Some important data in eeprom was changed.
CT U Error The current transducer on U phase is wrong.
CT V Error The current transducer on V phase is wrong.
CT W Error The current transducer on W phase is wrong.
Power Supply ERR The input power is wrong.
IPM Overheating The temperature of controller gets too high.
Pump Blocked The pump is blocked and controller can't start it.
Cable Error The output cable connection is wrong.
Waiting Contact service department
PFC Error Contact service department
No water No water in pump.
Timer set Error There is an input error when setting the timer. Control the timer settings or choose other timer.