Continuous Measurement Mode - Parkside PLEM 50 A1 Bedienungs- Und Sicherheitshinweise

- If no button is pressed for 30 seconds, the laser pointer and
display back-light will turn off. If no button is pressed for 3
minutes, the device will power off itself.

Continuous Measurement mode

Continuous measurement involves taking series of measurements
from which the maximum (MAX) and minimum (MIN) values are
displayed. To do this, move the device along a base surface or an
edge from which you wish to the measure a distances. You can, for
example, measure how parallel two opposite walls are or measure
the maximum values while using a function.
1. Start the continuous measurement by briefly pressing the con-
tinuous measurement button
observed to get first measured value on the display. This is com-
mon. Now, each measured value will be shown on the display.
2. Stop the measurement by pressing the continuous measure-
ment button
. The display now shows the maximum (MAX) and mini-
8
mum (MIN) values
and the last measured value.
Note:
- Repeat the step 1 to 2 if needed to do another measurement.
- Distance Measurement mode icon
tinuous measurement mode while measurement is on process.
- Addition, subtraction, area measurement and volume measure-
ment cannot be done on on this mode. So, function selection
14
or MEAS button
14
of that particular measurement series
21
. A very short delay could be
or return / Clear button
16
will be flashing under con-
26
GB 19