Warranty; Safety Precautions - HQ -DIGICHAR100 Anleitung

and negative (-) of the battery (please refer to Fig. A).
(Attention: Only inside two spring contactors are active for this
function)
Plug the AC or DC adapter into the power input socket (9), press and
hold the "Revive" button (5) on the left side of the charger for 3 seconds
until (13) and (15) LED turn on, then release the button (5) to start
charging.
If the red LED (14) does not turn on after the AA/AAA rechargeable
Ni-MH batteries are installed, it indicates that the batteries are over-
discharged. Please plug the AC or DC adapter into the power input
socket (9), press and hold the "Revive" button (11) on the right side
of the charger for 1 to 2 seconds until the red LED (14) turns on, then
release the button (11) to start charging.
Note: Some lithium batteries (Sony, JVC, Panasonic, etc.) have a "data
chip terminal" marked with "©". DO NOT contact these terminals with
spring contactors during operating the manual rejuvenating function to
avoid irrevocable damage (please refer to Fig. B).
9. LED Flashlight Function
Please install a (fully) charged Lithium-ion or 2 AA or AAA Ni-MH
batteries into the battery tray. Then press the LED flash light button (5)
to turn the LED flash light on and off.
10. CAUTION
This charger is only applicable to 3.6 / 3.7V or 7.2 / 7.4 V lithium-ion
batteries, AA / AAA Ni-MH rechargeable batteries.

Safety precautions:

CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
and other equipment if a problem should occur. Do not expose the product to
water or moisture.
To reduce risk of electric shock, this product should
ONLY be opened by an authorized technician when
service is required. Disconnect the product from mains
6
Fig. A
Fig. B
Maintenan
Clean only w

Warranty:

No guarantee
product or da
General:
Designs and
All logos bran
their respecti
Keep this ma
Attention:
This p
electr
There
1. Kompon
1. Umsc
2. Wink
3. Entsp
4. Entsp
5. Wied
6. LED-
7. Entsp
8. Rück