Lighting Instructions - Napoleon BIPRO 500 Bedienungsanleitung

8

Lighting Instructions

EN
!
WARNING!
WARNING!
supply valve.
2. Push and turn any main burner
knob slowly to the high position. If
the pilot lights, continue to push
down on the control knob until the
burner lights and then release.
3. If the pilot does not ignite, then
immediately turn the control knob
back to the 'off position and repeat
4. If the pilot and burner will not
ignite within 5 seconds, turn the
control knob to the 'off' position and
wait 5 minutes for any excess gas to
dissipate. Either repeat steps 2 and 3
5. If lighting the unit with a match, clip
the match into the supplied lighting
rod. Hold the lit match down through
the grill and sear plate while turning
the corresponding burner valve to
!
NOTE!
www.napoleon.com
N415-0541CE-GB-DE.indd 8
Igniter
Left Left Centre
Burner Burner
Open lid
Ensure all burner controls are in the off position. Slowly turn on the gas
Main Burner
Lighting
1. Open grill lid
step 2 several times.
or light with a match.
high.
Do not use rear burner while operating main burner.
Rear
Right Centre Right
Burner
Burner Burner
Rear Burner Lighting
(if equipped)
1. Open grill lid
2. Remove warming rack.
3. Turn rear burner control
to high position.
4. Press and hold
igniter button until burner
lights, or light by match.
5. If ignition is not
immediate, turn burner
control off. Wait 5 minutes.
Repeat.
Lights
Off Position
Side Burner Lighting
(optional)
1. Open burner cover.
2. Turn side burner control to
high position.
3. Press and hold
igniter button until burner
lights, or light by match.
4. If ignition is not
immediate, turn burner
control off. Wait 5 minutes.
Repeat.
N415-0541CE-GB-DE JuNE 04.19
6/4/2019 10:28:52 AM