Setup / First Use; Display Indicators; Using The Product - Silvercrest HG04155 Bedienungs- Und Sicherheitshinweise

Setup / First use

P lace the product on a suitable, level
surface.
O pen the lid
P ull the plug
opening .
3
P our liquid soap into the soap tank.
Note: During filling, note the "Max"
mark that is visible, if you look into the
soap tank. Never exceed the "Max"
mark when filling with soap! Otherwise,
the product may overflow (see Fig. A).
Note: Pour in at least 70 ml of soap;
otherwise, the "Fill level" indicator
will flash.
R eplace the plug
opening .
3
R emove the protective film from the
display and close the lid
9
product is now ready for use.

Display indicators

Note: The display indicators are only visible
if the lid is open.
1
The "Soap quantity" indicator
the amount of soap dispensed for each
use.
The "Fill level" indicator
much soap remains in the soap tank.
The fewer bars are visible, the less soap
there is in the soap tank. If only one bar
remains the "Fill level" indicator
gins to flash. Refill the soap tank.
Note: Pour much soap in the soap tank
until the display stops flashing.
The "Battery" indicator
charge level of the batteries that have
10 GB/CY
.
1
from the soap refill
2
13
in the soap refill
2
. The
1
shows
12
shows how
13
13
shows the
14
been inserted. If only one bar remains
you should replace the batteries soon.

Using the product

S et the quantity of soap you want dis-
pensed for each use. Press the "+" button
or "-" button
10
desired setting is displayed. You can se-
lect from four soap quantities. The more
drops displayed in the "Soap quantity"
indicator
H old your hand underneath the soap
outlet
8
soap.
A s soon as dispensing stops, you can
withdraw your hand.
Note: The soap dispensing also stops
as soon as you withdraw your hand. This
is true even if the programmed quantity
has not yet been dispensed.
I f you do not intend to use the product
for long periods, press the "-" button
repeatedly until "OFF" appears in the
display
P ress the "+" button
back on.
Note: If you need to remove a large
quantity of soap from the soap tank, you
can let the soap dispensing run for 30
seconds: Press the „+" button
the „-" button
hold them for about three seconds. The
product begins dispensing soap and stops
be- after 30 seconds.
Note: If you have not used the product
for several days, you may have to activate
the soap dispensing function several
times in a row before soap is dispensed
again.
repeatedly until the
11
, the more soap is dispensed.
12
. The product starts dispensing
.
9
to turn the product
10
simultaneously and
11
11
and
10