Example Of A Cleansing Cycle Followed By A Massage - Silvercrest SGRS 3.4 A1 Bedienungsanleitung

9.2. Example of a cleansing cycle
followed by a massage:

Wash face, remove any make-up, rinse and dry off.

Cleansing cycle (operating mode A)

Wash face, rinse, dry off.

Massage cycle (operating mode B)
An exact description of operating modes A and B can be
found under point 10.2. and 10.3. of these instructions.
The recommended time for a cleansing or
massage cycle is approx. one minute for each.
You can shorten or extend this time according
to preference. Try not to cleanse the eye area
using the face cleansing brush (A). This can be
painful due to their size and the sensitivity of
the eye area. To avoid skin irritation, however,
each cleansing and massage cycle should not
exceed three minutes. This is why the face
cleansing brush (A) automatically switches off
after around three minutes when in cleansing or
massage mode.
After approx. 15 seconds of operation (after
12 seconds in massage mode) the vibration
briefly cuts out once. After the first minute in
cleansing or massage mode, the vibration cuts
out briefly three times. Use these signals to
spread out the cleansing and massage cycle
evenly over the different areas of the face.
SilverCrest SGRS 3.7 A1
English - 93