Yamaha HTR-6140 Bedienungsanleitung Seite 27

4
Make sure that "SETUP" is set to "AUTO"
and the pointer is pointing at "START".
y
You can also select the following setup methods. In this
k
case, press 7 to select "SETUP", press 7 l / h to
select the one of the following choices and then select
"START".
Choices: AUTO, RELOAD, UNDO, DEFAULT
• Select "AUTO" to automatically run the entire
"AUTO SETUP" procedure.
• Select "RELOAD" to reload the last "AUTO
SETUP" settings and override the previous
settings.
• Select "UNDO" to undo the last "AUTO SETUP"
settings and restore the previous settings.
• Select "DEFAULT" to reset the "AUTO SETUP"
parameters to the initial factory settings.
Note
"RELOAD" or "UNDO" is available only when you have
previously run "AUTO SETUP" and confirmed the results.
5
Press 7 n to select "START" and then press
7 ENTER to start the setup procedure.
The following message appears in the OSD.
NOTICE
Loud test tones are
output.
Please keep quiet
or leave the room.
Press [ENTER]
Before proceeding next operation
Once you perform the next operation, this unit starts the
automatic setup procedure. For more accurate
measurements, keep quiet and move to the wall where
speakers are not around. We recommend that you leave
the listening room during the automatic setup
procedure.
Optimizing the speaker setting for your listening room
Press 7 ENTER to start the setup
6
procedure.
This unit starts the auto setup procedure. Loud test
tones are output from each speaker during the auto
setup procedure. Once all items are set, the result
display appears in the OSD.
Notes
• During the auto setup procedure, do not perform any
operation on this unit.
• We recommend getting out of the room while this unit is in
the auto setup procedure. It takes approximately 3 minutes
for this unit to complete the auto setup procedure.
This unit performs the following checks:
Speaker wiring/volume level WIRING/LEVEL
Checks which speakers are connected and the
polarity of each speaker. Also checks and adjusts the
volume level of each speaker.
Speaker distance
Checks the distance of each speaker from the
listening position and adjusts the timing of each
channel.
Speaker size SIZE
Checks the frequency response of each speaker and
sets the appropriate low-frequency crossover for each
channel.
DISTANCE
25
En