Troubleshooting - Yamaha HTR-5730 Bedienungsanleitung

Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed
below or if the instruction below does not help, set this unit to standby mode, disconnect the power cord, and contact the
nearest authorized YAMAHA dealer or service center.
I General
Problem
This unit fails to turn
The power cord is not connected or the
on when STANDBY/ plug is not completely inserted.
ON (or POWER) is
pressed, or enters in The protection circuitry has been
standby mode soon
activated.
after the power has
been turned on.
This unit has been exposed to a strong
external electric shock (such as lightning
and strong static electricity).
No sound. Incorrect input or output cable connec-
tions.
No appropriate input source is selected.
The speaker connections are not secure.
The front speakers to be used have not
been selected properly.
The volume is turned down.
The sound is muted.
The signals this unit cannot reproduce are
being received from a source component
e.g.: a CD-ROM.
The sound suddenly The protection circuitry has been
goes off. activated because of a short circuit, etc.
The sleep timer has turned the unit off.
The sound is muted.
No sound / weak Incorrect cable connections.
sound from particular
speakers.
No sound from the The sound effect is switched off.
effect speakers.
A Dolby Surround, Dolby Digital or DTS
decoding program is being used with
material not encoded with Dolby
Surround, Dolby Digital or DTS.
A digital signal with a sampling
frequency of greater than 48 kHz is input
to this unit.
48

TROUBLESHOOTING

Cause
Connect the power cord firmly.
Make sure all speaker wire connections on this unit
and on all speakers are secure and that the wire for
each connection is not touching anything other than
its respective connection.
Set this unit in standby mode, disconnect the power
cord, plug it back in after 30 seconds, then use it
normally.
Connect the cables properly. If the problem persists,
the cables may be defective.
Select an appropriate input source with INPUT l /
h or 6CH INPUT (or the input selector buttons).
Secure the connections.
Select the proper front speakers with SPEAKERS A/
B/OFF.
Turn up the volume.
Press MUTE or any operation buttons of this unit to
cancel a mute and adjust the volume.
Play a source whose signals this unit can reproduce.
Check that the speaker wires are not touching each
other and then turn the unit back on.
Turn on the power, and play the source again.
Press MUTE or any operation buttons on the unit to
cancel a mute and adjust the volume.
Connect the cables properly. If the problem persists,
the cables may be defective.
Press STEREO to turn it on.
Select another sound field program.
Remedy Refer to
page
–
15 – 16
–
9 – 16
21
15 – 16
21
22
–
–
–
–
–
15
–
24 – 29
–