About Bluetooth Icons; Connection; To Switch The Bluetooth Signal Output Of; Connecting A Cellular Phone - Sony MEX-BT2500 Bedienungsanleitung

About Bluetooth icons

The following icons are used by this unit.
lit:
flashing:
off:
lit:
flashing:
off:
lit:
flashing:
off:

Connection

If pairing has already been achieved, start
operation from here.
To switch the Bluetooth signal
output of this unit to on
To use the Bluetooth function, switch the
Bluetooth signal output of this unit to on.
1
While the unit is turned off, press and
hold (EQ/BLUETOOTH) until "
(about 3 seconds).
Bluetooth signal is switched to on.

Connecting a cellular phone

1
Be sure that both this unit and a
cellular phone are switched to
Bluetooth signal on.
2
Connect to this unit using your
cellular phone.
" "appears when the connection is made.
Connecting the last-connected
cellular phone from this unit
1 Be sure that both this unit and the cellular
phone are switched to Bluetooth signal on.
2 Press (SOURCE) repeatedly until "BT
PHONE" appears.
3 Press
(handsfree).
" " flashes while the connection is being
made. And then "
14
connection is made.
Bluetooth signal on
Pairing standby mode
Bluetooth signal off
Connection successful
Connecting
No connection
Connection successful
Connecting
No connection
" lights
" stays lit when the
Note
While streaming Bluetooth audio, you cannot connect
from this unit to the cellular phone. Connect from the
cellular phone to this unit instead. A connecting noise
may be heard over playback sound.
Tip
With Bluetooth signal on: when the ignition is switched
to on, this unit reconnects automatically to the last-
connected cellular phone. But automatic connection
also depends on the cellular phone's specification. If
this unit does not reconnect automatically, connect
manually.

Connecting an audio device

1
Be sure that both this unit and the
audio device are switched to
Bluetooth signal on.
2
Connect to this unit using the audio
device.
" " appears when the connection is made.
Connecting the last-connected audio
device from this unit
1 Be sure that both this unit and the audio device
are switched to Bluetooth signal on.
2 Press (SOURCE) repeatedly until "BT
AUDIO" appears.
3 Press (6).
" " flashes while the connection is being
made. And then "
connection is made.

Handsfree talk

Receiving calls

When receiving a call, a ring tone is output from
your car speakers. Check that the unit and
cellular phone are connected beforehand.
1
Press (handsfree) when a call is
received with a ring tone.
The phone call starts.
To end a call
Press (handsfree) again.
To reject an incoming call, press and hold
(handsfree) for 2 seconds.
Note
The microphone of this unit is located on the rear of
the front panel (page 9). Do not cover the microphone
with tape, etc.
" stays lit when the