Placing The Tabletop In Vertical Position; Adjusting Casters - Steelcase Verb FlipTop Bedienungsanleitung

_______________________________________________________________
horizontal position with the aid of the flipping
mechanism.
Lock all casters in place

Hold tabletop firmly

 Use your foot to move the lower lever against
the stop
or
 Use your hand to move the upper lever against
the stop
=
The tabletop lock is released
Use your foot to press against the tabletop

while simultaneously using one hand to pull the
upper tabletop area towards you until the
tabletop has reached the horizontal position
and snaps in place.
When the tabletop has reached the
correct position, it will snap in place.
5.3 Placing the tabletop in
vertical position
EN
Risk of physical injury!
A rolling-away conference table / training
room table with an unlocked tabletop can
cause physical injury.
 Lock all casters in place before
engaging the lever.
Figure 5-2: Work surface can be flipped either way
10
Operation adjustments
The tabletop of the Verb FlipTop conference table
/ training room table can be brought to the vertical
position to save space.
Remove all objects from the tabletop of the

conference table
Disconnect the power set connector from the

mains
Lock all casters in place

Hold tabletop firmly

 Move the lever under the tabletop against the
stop
The tabletop lock is released
=
Raise the tabletop and push it towards the rear

while simultaneously using your foot to press
against the lower tabletop area until the
tabletop has reached the horizontal position
and snaps in place.
When the tabletop has reached the
correct position, it will snap in place.
A flipping mechanism is located on both
sides of the conference table / training
room table.

5.4 Adjusting casters

Figure 5-3: Adjusting casters
The tabletop height can be increased by 10 mm by
adjusting the casters.
 Engage the arresting elements to adjust the
table to the preferred height and lock the
casters in place
129117