Operating Instructions; Coupling Up - V. Orlandi E 50 Einbau-, Bedienungs- Und Wartungsanleitung

3.1 COUPLING UP

This chapter refers to the figures on pages 12-15/32.
Read the following instructions carefully before any operation:
Wear working gloves
ATTENTION: Before coupling operation check that the brake of the trailer
is on and that in case of a steering axle trailer the front axle is free to
steer. Make sure that the drawbar eye and the coupling are level or that
the eye is slightly lower so that it runs up the lower jaw. If coupling a
central axle trailer, ensure that the rear support jacks, if fitted, are clear
of the ground first.
14
Attention! Risk of a limb injury
Lift the operating handle (22A-22B) upwards as far as it will go (note: minimum
1)
force needed is 200 Nm).
The coupling pin (14) is now raised. Check that the coupling jaw (13) has
locked, ie. cannot swing from side to side.
The security pins (18e) will now be protruding from their seats;
DRAWBAR COUPLING E 50
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS

3 OPERATING INSTRUCTIONS

18e
22A 22B
13
22A 22B
18e
14
PAG.
12/32
CHAP . 3
REV. F
13