Data Plate - Dometic CS 52 Bedienungsanleitung

Congratulations to your choice of a Dometic Wine Cellar !
Operating and Installation
Instructions for your
Dometic Wine Cellar
Introduction
Thank you for choosing the Dometic Wine Cellar.
Please read the following instructions carefully before
installing your new wine cellar. We trust you will be
completely satisfied with your purchase.
The wine cellar must be installed and used according
to these instructions in order for it to operate correctly
and economically.
Transit damage
Inspect the wine cellar for transit damage. You must
report any damage the company responsible for the
delivery within the legal or stated time for this type of
product. If there is no such established report time, the
damage must be reported within seven days of
delivery.
Accessories
Please check that the following accessories are
attached to the Wine Cellar. On the back or inside the
Wine Cellar.
At the back:
1. Distance bar
1
Inside the Wine Cellar:
1. Instruction manual
2. Handle
3. Drip tray
4. Keys
3
4
2
Necessary additional tools not incuded
1. Screwdriver (star quad )
2. Adjustable spanner or fixed spanner ( 21mm )
1

Data plate

Check the data plate, inside the wine cellar at the top
left, to ensure you have received the right model.
The data plate shows details that you will need to
quote if you have to contact service personnel. It is a
good idea to make a note of them here.
Model designation ...............................
Product number ..................................
Serial number .....................................
Voltage ..............................................
Installation
Please follow these installation instructions:
For best performance, air needs to circulate freely over
the cooling unit behind the wine cellar. The free-
standing design of the cellar means that it should
stand at least 25 mm from the rear and side walls.
Allow a clearance of at least 100 mm above the wine
cellar. FIG 1
Steel rod
FIG. 1
Steel rod
Rear
30 mm
Wall
25
25
Wall
7