Before First Use - Silvercrest SDMF 1630 A1 Bedienungs- Und Sicherheitshinweise

Do not pull the power plug out
¾
of the power outlet by the power
cord . Do not wrap the power
cord around the product .
Protect the product, its power
¾
cord and power plug against
dust, direct sunlight, dripping and
splashing water .
Store the product in a cool, dry
¾
place, protected from moisture
and out of the reach of children .
Burn hazards
Care should be taken when using
¾
the product due to the emission of
steam .
Touch the heated up product by
¾
its handle only .
Steam is very hot . Never put
¾
your hands in front of the steam
nozzles .
Never touch the steam nozzles
¾
in operation or while heated up
(e .g . to test the temperature) .
Keep the product and its cord
¾
out of reach of children less
than 8 years of age when it is
energized or cooling down .
30 GB/MT
˜ Before first use
Remove the packaging . Check if all parts are
¾
complete .
Clean the product (see "Cleaning and care") .
¾
NOTE: The product may give off some vapours
or odours during first use . These are production
or transport residue that will quickly subside .
There may also be quiet noises such as clicking
or crackling . These will also quickly subside
once the plastic parts have finally adjusted to the
operating conditions .
˜ Operation
˜ Filling/draining the water tank
DANGER! Risk of electric shock! Before
filling the water tank 6 : Disconnect the power
plug 9 from the power outlet .
NOTES:
Fill the water tank 6 with tap water or distilled
¾
water without any additives . Use the following
mixtures according to your regional water
hardness:
Water hardness Water
Soft
Medium hard
Hard
Your local water utility can inform you about
your region's local water hardness
The water tank 6 has a filling capacity of
¾
approximately 250 ml .
The MAX marking 8 for the maximum filling
¾
capacity applies when the water tank 6 is
positioned vertically .
Tap water
Distilled and tap water
(Ratio: 1:1)
Distilled water